User Tools

Site Tools


full_mission_builder_-_vehicles_moving

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
full_mission_builder_-_vehicles_moving [2020/02/26 05:40]
Artist
full_mission_builder_-_vehicles_moving [2020/02/26 09:47] (current)
Artist
Line 7: Line 7:
  
 Vehicles with country "​United Kingdom"​ ('... gb' in .mis file) will drive on the //left// side of the path (if the path follows a road). All other country settings will make it drive on the //right// side. Make sure that you don't mix vehicles with "​United Kingdom"​ with vehicles from other countries on the same road at the same time. Especially if you have oncoming traffic. Vehicles with country "​United Kingdom"​ ('... gb' in .mis file) will drive on the //left// side of the path (if the path follows a road). All other country settings will make it drive on the //right// side. Make sure that you don't mix vehicles with "​United Kingdom"​ with vehicles from other countries on the same road at the same time. Especially if you have oncoming traffic.
 +
 +With //convoys// and //columns// always take into account that they need a couple of hundred meters to sort themselves out, so set the starting waypoint accordingly.
  
 If the path follows a road: Always check that all your waypoints actually are on the road and not slightly beside it. The AI will try hard to follow the path you set. So really zoom closely in to check. If the path follows a road: Always check that all your waypoints actually are on the road and not slightly beside it. The AI will try hard to follow the path you set. So really zoom closely in to check.
  
-Always check that there are no kinks or zig-zags in you path. Especially if the path follows a road, ther might be unintended zig-zags at the first an last waypoint. The AI will try hard to follow these and might get confused. So really zoom closely in to check.+Always check that there are no kinks or zig-zags in your path. Especially if the path follows a road, there might be unintended zig-zags at or between ​the waypoints. The AI will try hard to follow these and might get confused. So really zoom closely in to check.
  
-When the path runs over bridges: Place a waypoint just before the bridge. Check status bar for '​...br0'​ and '​...br1'​ and place it where it's still '​...br0'​.+When the path runs over a bridge: Place a waypoint just before the bridge. Check status bar for '​...br0'​ and '​...br1'​ and place it where it's still '​...br0'​.
  
-Vehicle columns and bridges: Make sure that the first (starting) waypoint is well before any bridge, so that the column can sort itself before reaching the bridge. Place a second waypoint just before the bridge - check status bar for '​...br0'​ and '​...br1'​ and place it where it's still '​...br0'​.+Vehicle ​//columns// and bridges: Make sure that the first (starting) waypoint is well before any bridge, so that the column can sort itself before reaching the bridge. Place a second waypoint just before the bridge - check status bar for '​...br0'​ and '​...br1'​ and place it where it's still '​...br0'​.
  
  
  
full_mission_builder_-_vehicles_moving.txt ยท Last modified: 2020/02/26 09:47 by Artist